Thingiverse
SV01 Rail Adaptor
por Derpimus
0
Descargas
1
Likes
0
Makes
This is a modification to the right side rail adaptor in the Belt Driven Ender 3 to adapt to the SV01.
Everything else in the Ender 3 setup works, but the tapped hole on the inside if the X gantry is in a slightly different spot on the SV01.
I just elongated the hole on the bracket to make it adjustable.
You will probably have to drill out the right side plate where it bolts to this rail adaptor to allow for the 3mm difference.
Everything else in the Ender 3 setup works, but the tapped hole on the inside if the X gantry is in a slightly different spot on the SV01.
I just elongated the hole on the bracket to make it adjustable.
You will probably have to drill out the right side plate where it bolts to this rail adaptor to allow for the 3mm difference.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!