Thingiverse
SV06 Bed Camera Mount
by Akshue
10
Downloads
2
Likes
0
Makes
A mount I threw together... Will fit the specific camera
https://www.amazon.com/dp/B07R4JH2ZV?psc=1&ref=ppx_yo2ov_dt_b_product_details
This slides around the spacers in the bed. Likely requires ABS due to direct, constant contact with the bed. I have not yet tested things - I cannot yet print in ABS.
Not yet sure if it will hold up to the heat - there is a little room (about 6mm) for sagging on the front, but if things sag too far the front piece may contact the front frame.
https://www.amazon.com/dp/B07R4JH2ZV?psc=1&ref=ppx_yo2ov_dt_b_product_details
This slides around the spacers in the bed. Likely requires ABS due to direct, constant contact with the bed. I have not yet tested things - I cannot yet print in ABS.
Not yet sure if it will hold up to the heat - there is a little room (about 6mm) for sagging on the front, but if things sag too far the front piece may contact the front frame.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
