SW-3 Mount Pinball Table

Mount for a SW-3 Solenoid to hold either directly to the table.

Mount underneath for the XY-MOS (https://www.amazon.co.uk/dp/B07TVHRYBB/ref=cm_sw_em_r_mt_dp_9VGDMT3QYSTM04BDABJ0?_encoding=UTF8&psc=1)

NOT SUITABLE FOR RESIN, The brittleness causes the screws for the relay to shatter. Could cause the solenoid to break the mount.

I have printed at 0.15mm with PETG at 245C with gyroid infill, Print with the hoop on the bed to make the layers run perpendicular to the load of the solenoid. (Don't have the layers in the same direction)