SW BTL-B Y-Wing (TinyMaker Split)

This is a remix of AstroFossil's BTL-B Y-Wing that is split in order to best be printed by TinyMaker resin 3D printers with a build volume of 30.6 x 40.8 x 54mm. In addition to splitting the model, I also took the liberty of filling in the engine cavities since I found on my first print that they were very brittle in resin and liked holding onto extra liquid resin. This model is in 1/270 scale, matching the scale of X-Wing Miniatures. The peg hole on the bottom will probably require some widening in order to fit a standard peg, it did when I printed using Elegoo standard dark grey resin. I may modify the model at a later time but as of right now it's not much of an issue. Enjoy!

NEED TO KNOW: When rafts and supports are added prior to printing, the rafts may extend off the side of the build plate. THIS IS OKAY! It caused no issues during printing and the picture is of my print with a modified turret (cut down AT-AP cannon, if you must know ;) ) I also recommend using super