Thingiverse
Sweep 2.x Case
por Knifa
36
Descargas
37
Likes
1
Makes
This is a little case for the [Sweep 2.x by @davidphilipbarr](https://github.com/davidphilipbarr/Sweep), intended to be printed in a soft TPU. It includes cut outs for the solder joints so the board can sit completely flush.
This was built around the Sweep 2.1 specifically, but I think it should also fit the Sweep 2!
This was built around the Sweep 2.1 specifically, but I think it should also fit the Sweep 2!
Knifa también publica en
4 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
