Thingiverse
Sweet Tsurikawa
von komiPrints
6
Downloads
15
Likes
0
Makes
Designed as a gift for my buddy, uploaded so it can be a gift for your buddies too.
Tsurikawa's in this context are essentially subway handle decorations for cars.
You can read the lore here: https://www.pasmag.com/extras/gear/jdm-tsurikawa-strap
This one reads "Sweet"
Made to fit 1-inch nylon webbing.
https://amzn.to/3Nci6NO
Requires some hardware:
- 2x 12mm M5 Screws
- 2x M5 Nuts
https://bit.ly/3uOfiAc
Assembly:
1. Measure & cut the webbing to the length desired that you'd like the handle to hang.
2. Use the locks to mark three sets of holes on the webbing, and hole punch them.
3. Partially thread the M5 screws and hook your webbing over them.
4. Press the M5 Nuts into the lock back.
5. Tidy up and screw closed.
Tsurikawa's in this context are essentially subway handle decorations for cars.
You can read the lore here: https://www.pasmag.com/extras/gear/jdm-tsurikawa-strap
This one reads "Sweet"
Made to fit 1-inch nylon webbing.
https://amzn.to/3Nci6NO
Requires some hardware:
- 2x 12mm M5 Screws
- 2x M5 Nuts
https://bit.ly/3uOfiAc
Assembly:
1. Measure & cut the webbing to the length desired that you'd like the handle to hang.
2. Use the locks to mark three sets of holes on the webbing, and hole punch them.
3. Partially thread the M5 screws and hook your webbing over them.
4. Press the M5 Nuts into the lock back.
5. Tidy up and screw closed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!