Swimbait

5 Piece Segmented Swimbait I designed in fusion 360 then Airbrushed (Work In Progress )

5 1/2 Inch length.

Uses eye bolts and small nails to create hinges.

Lighter Infill (less than 50) will allow the lure to float while 100% infill causes the lure to sink.

Some tuning might be needed to get these to stay upright in the water but I haven't had much difficulty in doing so (Note lighter lures seem to be just fine with the weight of the hooks being able to keep the lure upright, the 100% infill tends to lay over when the retrieve is stopped, some additional weight at the bottom of the belly resolves this.)

⚠️⚠️Until I can get predetermined hard points inserted into the body I recommend printing this at a dense infill ( more than 30%) this just insures that the eyebolts have sufficient material to hold onto and not just pull out of the lure.⚠️⚠️

CHANGE SLICER UNITS TO MM or else HARWARE WILL NOT FIT!

This thing makes plenty of noise as is but a rattle can be added