Thingiverse
Swimbait
von Brarups
67
Downloads
36
Likes
0
Makes
Print on 0.12mm layer hight
First layer is for better bed adhesion.
Just remove useless material, when the print is finished.
Use 2mm thick acrylic glass for the tail fin.
First layer is for better bed adhesion.
Just remove useless material, when the print is finished.
Use 2mm thick acrylic glass for the tail fin.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
