Thingiverse
Switch 2 Dock Wall Mount
por Mick_GT
0
Descargas
4
Likes
0
Makes
For use with 3m strips, I used the velcro ones.
Print with logo facing UP. I used adaptive layer height and conventional supports with .25mm floor and ceiling spacing.
Sand with 120 grit where you intend to put command strips, then wash with isopropyl.
Print with logo facing UP. I used adaptive layer height and conventional supports with .25mm floor and ceiling spacing.
Sand with 120 grit where you intend to put command strips, then wash with isopropyl.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
