Switch Blade (USB stick)

This custom upgrade for your boring USB stick is Simple to print and assemble in less than 1h30m

* Additional parts not printable include:

- USB Electronics
- Crazy Glue
- 2 pen springs
- Fabric (Customizable)

*Instructions:
- scale and print plastic components
- clip in electronic component (i used a"Kingston datatraveler 3G" )
- glue inner 2 pieces together
- inset springs at back
- line up outer pieces but do not glue them together
- wrap fabric in notch around outside of USB
- with small brush cover the fabric in a layer of glue (be very careful not to glue any moving pieces)

*Trouble shooting:
-if the USB dose not slide use nail polish remover and oil to clear and bits of leftover glue and lubricate the track