Switch holder for Skadis

### What is it?

It's a switch holder for Ikea Skadis! It can hold a little slide switch with M2.5 screws with or without nuts. It uses a hook and a peg to secure it in the typical oblong spacing of the skadis plate.

### Why though?

Wifey got me a nice neon light of a controller, I wanted to fit it in my skadis network "rack" but I didn't want to have the switch dangling around so I had this idea to make a holder for a little switch.

### Will it fit?

Short answer, yes.

It's snug because I didn't want it to move around when I flick the switch. The hook has rounded edges to make insertion easy.
Bear in mind it uses 2 holes in the skadis plate, top hole for the hook, bottom hole for the peg.
I made sure there is enough space for the wires to comme either way.

For the screws I used M2.5x4mm but you can go up to M2.5x10mm

I'll say it again in the print note but:
# Print the support on it's side
Otherwise the hook will snap, see the print note for more info

### How should I print thi