Thingiverse
Switch holder - small
door AMDFenics
10
Downloads
7
Likes
0
Makes
I created this small holder, to be able, to mounting the switch.
I printed this in PETG with 0.2 Layerheigh.
inside width is 12mm and lenght is 19mm
All sides are 2mm thick.
The switch fits perfectly in, i just didn't do put him in completly, because i needed
to cable the switch first. So i had to pull him out again.
I printed this in PETG with 0.2 Layerheigh.
inside width is 12mm and lenght is 19mm
All sides are 2mm thick.
The switch fits perfectly in, i just didn't do put him in completly, because i needed
to cable the switch first. So i had to pull him out again.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
