Thingiverse
Switch trigger without hose holder
door Sound-Maker
4
Downloads
4
Likes
0
Makes
Das tolle Design von FrankBer fand ich sehr zweckmäßig und habe das an meinem neuen DMP181Z Kompressor getestet.
Es funktioniert auch an diesem Gerät einwandfrei. Ich habe das Design ohne die Schlauchklemmung modifiziert weil am
DMP181Z sind bereits drei entsprechende Halter vorhanden.
Gedruckt mit Prusa PETG, 60% Füllung, mit Rand.
So ist es recht flexiebel und kann am Gerät verbleiben.
--------------------------------------------------------------------
I found FrankBer's great design very useful and tested it on my new DMP181Z compressor.
It works perfectly on this device too. I modified the design without the hose clamp because the
DMP181Z already has three corresponding holders.
Printed with Prusa PETG, 60% filling, with edge.
So it is quite flexible and can remain on the device.
Es funktioniert auch an diesem Gerät einwandfrei. Ich habe das Design ohne die Schlauchklemmung modifiziert weil am
DMP181Z sind bereits drei entsprechende Halter vorhanden.
Gedruckt mit Prusa PETG, 60% Füllung, mit Rand.
So ist es recht flexiebel und kann am Gerät verbleiben.
--------------------------------------------------------------------
I found FrankBer's great design very useful and tested it on my new DMP181Z compressor.
It works perfectly on this device too. I modified the design without the hose clamp because the
DMP181Z already has three corresponding holders.
Printed with Prusa PETG, 60% filling, with edge.
So it is quite flexible and can remain on the device.
Sound-Maker publiceert ook op
12 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!