Switchbot Blind Tilt Holder for Multiboard

I wanted something to hold my Switchbot Blind Tilts when charging, as they have a tendency to fall over when standing up, so I created a holder for them. Built this for mounting to Multiboard and it snaps securly into the grid without any additional prints. It does require minimal supports when printing, but not much. Printed this in translucent material so the charging light would shine through it. I used gyroid infill, but probably should have used grid instead for a cleaner look. This was my first-ever from-scratch creation, so I didn't really do much to optimize it for minimal filament use, etc. Just needed something to solve the problem for myself.