SwitchBot Hygrometer Thermometer Wall Mount Case

After looking for a wall (Or any orientation!) mount for my SwitchBot Outdoor/Indoor Temperature + Humidity Meter I decided to design my own that resolved the problems I was seeing with other models on here and other sites.Boost MeHand me a boost if you wish to see more models like this and improve things further, thanks.🪨Secure Fit is made possible by making the design clamp around the device. This necessitates that the mount is printed on-its-side and is therefore designed to print best in that orientation. This is crucial as otherwise there is risk of splitting at layer lines after repeated insertion and removal (I have not seen any issues with this design so far in strength)🥷Concealed Fixing so to make the installation neat, crucially using two countersunk standard screw holes to allow for a stable fixture to most surfaces.⛈️Rain Drainage Holes are part of the model so that there is lower chance of water or ice building up around the sensor🍃Vented Rear Face is crucial when mount