Thingiverse
Switchbot K10+ Lower Bumper
por patele
0
Descargas
3
Likes
0
Makes
Lower bumper, as the robot tries to climb over my stools.
Printed in PLA, 3 layer shell, 15% infill
I've pinched the holes for the screws afterwards, as it's easier to get them correct. (Holes are slightly offset, feel free to fix, but it works.)
You will need longer screws, original ones are too short.
Printed in PLA, 3 layer shell, 15% infill
I've pinched the holes for the screws afterwards, as it's easier to get them correct. (Holes are slightly offset, feel free to fix, but it works.)
You will need longer screws, original ones are too short.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
