Thingiverse
Swivel Hinge UMPC
45
Downloads
40
Likes
0
Makes
Assembly instructions
1. Remove Ethernet port and all USB-A ports from pi 4. Be careful not to damage the pi.
2. Solder USB extension cable to pi. Plug usb receiver for keyboard into it. Solder a power cable attaching another pi usb to the miniusb on the keyboard. Take the small battery that came with the keyboard out.
3. Solder wires to GPIO pins, pass them through the hinge, then solder the other side to LCD
4. Solder wires to GPIO pins, then solder other side to arduino. Then solder a second usb from the pi to microusb plugging into the arduino.
5. Strip insulation off female HDMI to male micro HDMI cable and run it through the hinge. Plug micro HDMI side into pi.
6. Solder fan wires to gpio.
7. Screw hinge, pi, trackball, and fan into frame.
8. Screw 3 pieces of the top frame together, and screw the LCD to it using standoffs.
9. Plug in LCD to HDMI using the included 180 adapter.
10. Screw HDMI and screen guards onto metal top frame.
Screw & Nut list
4 M1.4 x
1. Remove Ethernet port and all USB-A ports from pi 4. Be careful not to damage the pi.
2. Solder USB extension cable to pi. Plug usb receiver for keyboard into it. Solder a power cable attaching another pi usb to the miniusb on the keyboard. Take the small battery that came with the keyboard out.
3. Solder wires to GPIO pins, pass them through the hinge, then solder the other side to LCD
4. Solder wires to GPIO pins, then solder other side to arduino. Then solder a second usb from the pi to microusb plugging into the arduino.
5. Strip insulation off female HDMI to male micro HDMI cable and run it through the hinge. Plug micro HDMI side into pi.
6. Solder fan wires to gpio.
7. Screw hinge, pi, trackball, and fan into frame.
8. Screw 3 pieces of the top frame together, and screw the LCD to it using standoffs.
9. Plug in LCD to HDMI using the included 180 adapter.
10. Screw HDMI and screen guards onto metal top frame.
Screw & Nut list
4 M1.4 x
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!