Thingiverse
Swiveled Hanger / Hook
di flatleyaia
19
Download
12
Likes
0
Makes
I need a sturdy hanger for my sail boat. When it heels over, I want a hanger that swivels - so things can't fall off the hook. And this is it!
- There are three hook sizes; Tall, Grande, Venti. (The photo shows Tall)
- There are two bases; one glues on (or 3M tape), one screws on.
- There are two dowels; one for the glue-on base, the other for the screw on base.
Printing is easy, no support or adhesion needed for the hook and bases. I print with triangle infill at 80% on Cura - I wanted this to be strong. For the dowels, I print on a little raft. For my next print of the base, I may set Cura for 50% infill near the bottom, and 100% infill near the top, where the greatest stresses on the part will be.
To glue the base to the inside of the hull of a boat, a nice trick is to put a dollop of epoxy in the middle, a ring of hot glue around the edges, and firmly press the piece against a clean, roughed area of the fiberglass. Make sure to sand the bottom of the base wi
- There are three hook sizes; Tall, Grande, Venti. (The photo shows Tall)
- There are two bases; one glues on (or 3M tape), one screws on.
- There are two dowels; one for the glue-on base, the other for the screw on base.
Printing is easy, no support or adhesion needed for the hook and bases. I print with triangle infill at 80% on Cura - I wanted this to be strong. For the dowels, I print on a little raft. For my next print of the base, I may set Cura for 50% infill near the bottom, and 100% infill near the top, where the greatest stresses on the part will be.
To glue the base to the inside of the hull of a boat, a nice trick is to put a dollop of epoxy in the middle, a ring of hot glue around the edges, and firmly press the piece against a clean, roughed area of the fiberglass. Make sure to sand the bottom of the base wi
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!