swx2 z axis brace

Created new parts based on dukedok's version (https://www.thingiverse.com/thing:5532822).
This one is for M10 575mm threaded rod (length can vary by+/- 5mm)
You need additionally M10 nuts and washers.
All other screws remain original.

I made all parts a little bit more stable. For the top ones this means, you need support for the middle part but non for the rest (see image below for example in cura).
In case you do not want to make use of supports you might go with the alternative top part.
Hence either print the individual left and right top parts or two times the generic top part.

I printed with cheap blue PLA, 0.2mm layer width and 10% Gyroid infill.
Print took ~1h for top and ~1:45h for bottom parts.

(1) Mount top ones first and attach rod loosely to it.
(2) Then loosely attache bottom part to other end of rod.
(3) Slip bottom part from side onto printer box, then fix first bottom part with screws.
(4) As last step tighten the rod again first on top then botto