SyncSign 7.5" Display Window Mount

The mount is designed to be stuck inside a window, so the display is visible but inaccessible unless you are inside the room. The top is screwed in by M2x6 Screws held by M2x3.5x6 Heat inserts, increasing security as one needs a screwdriver to gain access to the device. The device can be recharged with the charging hole below or removed from the mount by using the charging area as a way to push the device out once the top has been unscrewed. The recommended filament is PETG (HF) in white, or PLA for indoor, temperature-controlled environments with no direct sunlight. Assembly Instructions:Print both partsUse a soldering iron to insert a heat-insert nut into the holes at the top of the main shellCut three strips, each 8cm long, of clear ¼" wide VHB tape.Place the strips in the recessed areas in the main shellStick the main shell to the windowSlide in the SyncSign DisplayScrew in the lid with two M2x6mm long screws.