Tools
Zum Modell
Syringe dispenser tip
196
Downloads
158
Likes
1
Makes
I made this little dispenser tip in order to inject adhesive in hard to reach places. It's essentially a copy of one I had.
The dimensions are based on the existing tip and the Luer Lock ISO 594-2 standard. These dimensions were then tweaked to get good final dimensions with my Ender 5. I tested the dispenser on 3 different syringes and it fits on all 3. This design should technically fit any syringe that follows that standard.
Tip: If the print is not water tight, a bit of clear nail polish on the outside seems to do the trick
Have fun!
The dimensions are based on the existing tip and the Luer Lock ISO 594-2 standard. These dimensions were then tweaked to get good final dimensions with my Ender 5. I tested the dispenser on 3 different syringes and it fits on all 3. This design should technically fit any syringe that follows that standard.
Tip: If the print is not water tight, a bit of clear nail polish on the outside seems to do the trick
Have fun!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!