Thingiverse
Syringe Holder
von asomeone
1
Downloads
2
Likes
0
Makes
Simple syringe holder designed to hold 5 total "BD" - becton dickinson - syringes.
First two holes are for 10ml conventional syringes (16.6mm dia) The next three holes can hold either a 5ml or 3ml syringe (13.7mm dia).
I cut out the base to reduce print time, but due to this, it requires some rafts to stick to the bed if using PETG. 2 layers worked fine for me.
2 mounting holes in the print support 3mm diameter screws. Could always just drill them out though.
First two holes are for 10ml conventional syringes (16.6mm dia) The next three holes can hold either a 5ml or 3ml syringe (13.7mm dia).
I cut out the base to reduce print time, but due to this, it requires some rafts to stick to the bed if using PETG. 2 layers worked fine for me.
2 mounting holes in the print support 3mm diameter screws. Could always just drill them out though.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
