Thingiverse
Syringe Luer Tips
von gobgob30
0
Downloads
0
Likes
0
Makes
An assortment of tips and a holder that fits 20ml syringes
Nothing special other than print and use, lower resolution is preferable for these models
All luer fittings generated with [Luer Fitting Generator By nico-schluter](https://apps.autodesk.com/apps/98fc8bd4-ffc6-4f40-b9e8-3c3b6447d026)
- Luer Draw
- Kinda deprecated, is used to draw stuff up but kinda sucks, would be helpful perhaps if vaccumming with a syringe.
- Luer Taper Tip
- General drawing tip plus will go into rubber holes to draw up fluid, have electric sprayer that loses prime so helpful for that.
- Luer Tip
- Self explanatory, does have a point to allow you to remove air without the initial sputtering.
- Tip Holder
Nothing special other than print and use, lower resolution is preferable for these models
All luer fittings generated with [Luer Fitting Generator By nico-schluter](https://apps.autodesk.com/apps/98fc8bd4-ffc6-4f40-b9e8-3c3b6447d026)
- Luer Draw
- Kinda deprecated, is used to draw stuff up but kinda sucks, would be helpful perhaps if vaccumming with a syringe.
- Luer Taper Tip
- General drawing tip plus will go into rubber holes to draw up fluid, have electric sprayer that loses prime so helpful for that.
- Luer Tip
- Self explanatory, does have a point to allow you to remove air without the initial sputtering.
- Tip Holder
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
