Syrp Genie Mini Base

UPDATE - V12 is the better version INHO, when I realised the genie needs to between the ballhead and print.… Pics show a very rushed asa-cf print and before it's pointed out, yes the z is too close lol but for a prototype, who cares ;) On the underside is a layer of black craft foam then soft rubber sheeting. After starting timelapse photography again, I picked a up a Syrp Genie Mini (gen1) for cheap. I soon realised I should be able to to tilt moves, and not just pan. Looking into this, I was sure I needed a different mounting option. I spotted a bit of a "hack" on a YouTube thumbnail recently. Although this is not yet to be tested, in theory it should work well. You will need a length of 25mm (up to 35mm) width of webbing strap, and relevant fixings such as clips or tightening options. The two models (v1 is first revision with a flat base / bottom and v2 has a slightly curved bottom) have a 45mm recessed section as seen, which is the diameter of my ballhead's base. Th