Slicer Discord
Sys3 M foam cutting guide – 3D printable model from MakerWorld MakerWorld
Organizers

Sys3 M foam cutting guide

37 Downloads
16 Likes
7 Makes
Go to Model
Guide for cutting foam insert that fit into Sys3 MSplit the guide in your slicer, print and place on shadow foam or the like, cut and enjoy organizing into perfectly fitting foam.In order to make it bottom out in the systainer, the sides and front have to be trimmed at the bottom.Steps: See pictures :)Flip the cut foam over, lay the guide on top and cut on the inside of the guide as shown approx 15mm deep and 15mm into the side, on the sides and front. Then it should bottom out, otherwise cut a bit deeper.
Category
Organizers
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

JP-Designs also publishes on

26 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection