Thingiverse
Systema PTW Battery Stopper Cap replacement
par XeS0r
7
Téléchargements
4
Likes
0
Makes
Custom Systema PTW SST-009 Battery Stopper Cap replacement part.
**If you like my designs and don't mind I would be happy about a beer. (Tip Designer)**
Additional requirements:
* O-ring => ID: 17-19mm OD: 20-22mm (this is just what I've used! Other may fit too)
Printing:
Layer height: 0.1 - 0.3 mm
Support: yes (Touching Buildplate was enough for me)
Infill: 20 %
Brim: yes (not required)
Material: PETG (PLA should also work but is not recommended)
Assembly:
After printing remove the support material add the O-ring.
**If you like my designs and don't mind I would be happy about a beer. (Tip Designer)**
Additional requirements:
* O-ring => ID: 17-19mm OD: 20-22mm (this is just what I've used! Other may fit too)
Printing:
Layer height: 0.1 - 0.3 mm
Support: yes (Touching Buildplate was enough for me)
Infill: 20 %
Brim: yes (not required)
Material: PETG (PLA should also work but is not recommended)
Assembly:
After printing remove the support material add the O-ring.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !