T-Bar Knuckle (V2)

All the files for Brass Knuckles were not quite right for me, so decided to model a set that with minor post print work (Sand, Prime and then Paint) would pass for the real thing in films, photo shoots or stage plays for a prop department on a budget.

This file is for a set of Printable knuckles for Prop use, be sure to use flexible filament or print as few perimeters and as little infill as possible while still maintaining the integrity of the print, so it is easy to prove they are a prop and not actual Knuckle Dusters. Especially if they are prohibited where you live.

Finger holes are elliptical and measure 25mm wide by 28mm tall, if you have larger or smaller hands you may need to scale the model appropriately

This model will require supports to print to the best quality

V2 has thickened walls on the finger holes as the last were a little on the skinny side