Thingiverse
T-Caliper
door jonweb
2
Downloads
1
Likes
0
Makes
Hello Gentlemen, this is an addon for your caliper in order to trasform the orginal one to a T-Caliper to use to measure deep holes,steps, others.
I adapted it to my caliper MIB Germany 200 mm, but it is very to adptive modfing the drawing. Inside the hole for the caliper arms i add a little slide to avoid problem when you will block it by screw. The hole for the screw has been made in ordet to add a M3 RUTHEX insert. In order to tighten use a M3x12 screw
I adapted it to my caliper MIB Germany 200 mm, but it is very to adptive modfing the drawing. Inside the hole for the caliper arms i add a little slide to avoid problem when you will block it by screw. The hole for the screw has been made in ordet to add a M3 RUTHEX insert. In order to tighten use a M3x12 screw
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
