Thingiverse
T-mount Prop Washers
door JackLenders
3
Downloads
1
Likes
0
Makes
The washers are 1mm in hight making it possible to install T-mount drone props with the standard size M2 x 8 mm screws. Set of 4 washers.
Instead of of the hightly irregular size of M2 x 7mm normally used with these props.
Printing:
DO NOT USE TPU FOR THESE!!! Compression of washers printed in TPU can cause the screws to go in to deep and damage your motors.
So use a hard material like PLA of PETG for this
Have a good flight :-)
Instead of of the hightly irregular size of M2 x 7mm normally used with these props.
Printing:
DO NOT USE TPU FOR THESE!!! Compression of washers printed in TPU can cause the screws to go in to deep and damage your motors.
So use a hard material like PLA of PETG for this
Have a good flight :-)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
