Thingiverse
T12 tips holder
von diegogmx
2
Downloads
3
Likes
0
Makes
Circular holder for 15 T12 tips, to keep the tips straight even with a relatively low cylinder the tolerances are pretty tight (0.3mm id for the barrels) meaning the maximum calibration error for the 3d printer is apx 0.05mm/mm
Cleaning and/or sanding may be needed if there is residue inside the barrels for some reason
the support in the picture is made of abs, 0.1mm layer 0.3mm extusion diameter
THE TIPS GO UPWARDS, otherwise they will move and if you put them hot will burn the support
Cleaning and/or sanding may be needed if there is residue inside the barrels for some reason
the support in the picture is made of abs, 0.1mm layer 0.3mm extusion diameter
THE TIPS GO UPWARDS, otherwise they will move and if you put them hot will burn the support
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
