T4 Quadcopter Body - Split

The T4 is probably the best quad on Thingiverse right now. Just one problem, the full size version isn't printable on a basic 8" entry level printer. Well, it wasn't printable; because now it's been CUT! I just imported the STL to Sketchup and split the model to make it fit on a 8" print bed. The resulting two pieces must be welded back together. I didn't add any interlocking parts or pins because I just don't think it'll be strong enough to keep the quad together. If there is enough interest I could see about coming up with an interlocking design.

The best way I've found to weld printed parts together is to take some filament, about an inch or so; clamp it down in a dremel and run it along the seam. You'll find the right speed when you get in the groove. You may need do an initial tack weld with super glue to get the alignment just right on a flat surface.