T4R desk clock

uses a deans connector an a slightly modified clock from a lot of toyota models to make a desk clock. this is a work in progress and i may make it look fancier later but this is simple for now and prints quick with very little supports

i will add my make to give you an idea of the modifications but its basically sanding to make a tight fit and a piece of 3m take on the back cover.

if you remix this please give me a shout out that's all i ask

parts needed
male deans connector
female deans connector attached to a 12 household power supply
4 8mm long m3 screws
small piece of 3m double side tape
one toyota clock
sand paper for fitting


i only wired battery and acc to positive and left the illumination alone then wire the ground of course.
then i cut the old plug part off the clock