T8 Grow Light Stand

I have a lot of T8 grow lights hanging, but in some areas I really wanted a vertical “stick” style light instead. You can buy standalone vertical grow lights but this was a much more cost-effective way to use what I already had and it ended up costing far less than buying something new. I’ll link the exact grow lights I used below since the fitting is specific to these lights with the reflector fins. This print supports 2, 3, 4, and 6 ft grow lights. The middle connector piece comes in two sizes depending on your needs. Pictures show a 4ft grow light but I also have smaller 2 ft T8 grow lights. Grow Lights: (https://a.co/d/i7fz2Ft) This is my first design from scratch, so tolerances may vary for you. I printed it in PETG, although PLA would probably work fine as well. I used a bit of black electrical tape between the connectors to get a nice snug fit. Infill is set to 15%. It stands upright without any issues but the base is fairly light so it will tip over if bumped. I’ve thought abou