Thingiverse
Table Bracket for silent enclosure
por SEA17
38
Descargas
22
Likes
0
Makes
This is a remix of RuiJC and Thingirob bracket.
I build a silent printer enclosure mounted on IKEA Lack table.
Attaching printer to the Lack table directly will amplify the noise because the table is hollow and will work as a resonator (like in guitar).
To avoid that I use a rubber pad glued to table. And then the brackets are glued to to rubber pad. I use interlocking rubber mats similar to these: https://www.amazon.com/Terra-Flex-Interlocking-Rubber-Flooring-4x24x24/dp/B0035N2D4K
I cut the rubber to bracket size pieces. Alternatively it can be cut to one single rectangular piece for whole printer.
Left bracket updated again. Testing now
UPDATE April 2, 2020
I don't use this design - I did too many mods to printer to use this one.
Anyway, I created new enclosure set and will publish it here once all done.
I build a silent printer enclosure mounted on IKEA Lack table.
Attaching printer to the Lack table directly will amplify the noise because the table is hollow and will work as a resonator (like in guitar).
To avoid that I use a rubber pad glued to table. And then the brackets are glued to to rubber pad. I use interlocking rubber mats similar to these: https://www.amazon.com/Terra-Flex-Interlocking-Rubber-Flooring-4x24x24/dp/B0035N2D4K
I cut the rubber to bracket size pieces. Alternatively it can be cut to one single rectangular piece for whole printer.
Left bracket updated again. Testing now
UPDATE April 2, 2020
I don't use this design - I did too many mods to printer to use this one.
Anyway, I created new enclosure set and will publish it here once all done.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
