Table Catch for Filament Holder

Really liked the spool holder made by ROBO3D, then remixed by Invictable. Only issue one can find is it doesn't stay in place while being pulled from the spool. So I made this little plate you can print which will hold it at the edge of a table.

I printed on it's side I think that makes it a bit stronger.

Also if like me you found the Invictable's remix little wider than you need I found setting X scale to 80% is a good fit for my Inland Spools. Just make sure to remember to also adjust this the shaft and my holder accordingly.

Included the original files just because they were 10x sized in original post. This makes them normal sized.