Thingiverse
Table Corner Headphone Holder v1
door PantherCookies
2
Downloads
4
Likes
0
Makes
This corner headphone holder printed for me in about 9hrs at 20% infill and 0.3mm layer height on a cr-10s pro.
I may add a screw hole soon so that you can screw it into the table from below.
Fits
- Tabletop: 26mm high
60mm into the table on each side (above and below on x and y)
- Headband+cushion: 25 MM
I may add a screw hole soon so that you can screw it into the table from below.
Fits
- Tabletop: 26mm high
60mm into the table on each side (above and below on x and y)
- Headband+cushion: 25 MM
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!