Thingiverse
Table glass holders
door Vijit
33
Downloads
19
Likes
0
Makes
This a remix that I found on [3DToday](https://3dtoday.ru/3d-models/detali-dlya-3d-printerov/raznoe/derzhatel_originalnogo_stekla_dlya_creality_ender_3/).
Theses holders designed for replacement paper clamps for holding the glass on table.
Of course such holders shrinks the useful square of the table. But it is better then paper clamps.
I use holders on Ender 3 which have an aluminum table with height 3mm.
The holders are available in two sizes, for glass 3 or 4 mm (taking into account the height of the metal table).
Your final solution may vary. Use the image as an example only.
_Note: I haven't placed the holders on the left side cause Cura by default generates a "warm-up lane" there and the extruder will hit the holders. I often forget about it :)_
Theses holders designed for replacement paper clamps for holding the glass on table.
Of course such holders shrinks the useful square of the table. But it is better then paper clamps.
I use holders on Ender 3 which have an aluminum table with height 3mm.
The holders are available in two sizes, for glass 3 or 4 mm (taking into account the height of the metal table).
Your final solution may vary. Use the image as an example only.
_Note: I haven't placed the holders on the left side cause Cura by default generates a "warm-up lane" there and the extruder will hit the holders. I often forget about it :)_
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
