Slicer Discord
Table Golf Association (TGA) Insert – 3D-Druckmodell von Thingiverse Thingiverse

Table Golf Association (TGA) Insert

2 Downloads
1 Likes
0 Makes
Zum Modell

These are trays for the Table Golf Association 1st edition KS box w/ options for the KS Promos, Driving Range Expansion, European Expansion, 25 Bonus Tile Box. There are a few alternative prints that you can choose from {therefore, don't print everything below}. The pictures show the Base + KS Promos + European + Driving Range Expansions [50 tiles]{no lid lift and can be stored vertically}. Alternatively, the trays could have held the Base + KS Promos + 25 Bonus Tile box [56 tiles].

However, if you want to try and get all 75 Tiles into the box there would be a theoretical lid lift of approx. 3/4 inch. I increased the height of the trays shown in the picture. I did not print these but figured I would give the option to you to take those risks if you want to go for it.

There are also two options for card storage depending on your preference, both trays are shown in the pictures {one sitting inside a tile tray in the lower left (helps hold tiles in place for vertical stora
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen