Thingiverse
Table Leg Extender
by Sandus
1
Downloads
1
Likes
0
Makes
Im all new to this, so let me know if any information is missing.
My problem wich ended with this project:
I bought an old tabel and some old chairs, but the chairs couldet go under the table.
I designed a circel in TinkerCad with a diameter on 58mm wide and 15mm in height.
On top og that i made a circle with a hole in the same diameter of 58mm and set the wall for 1 which made it 3mm wide, so it wont brake off, so the hole is 55mm wide. I made the wall 10mm high, so the extender works like a cork and you dont need any screws.
Dimensions:
Bottom
58mm wide x 15mm high
Top
58mm wide x 3mm wall x 10mm high
You can modify the model for fitting your table leg. Measure the diameter and fit the model to it.
I attached a file from TinkerCad and the file from Cura. Guess Cura saves the settings from my printet setup.
Hope someone can use this.
My problem wich ended with this project:
I bought an old tabel and some old chairs, but the chairs couldet go under the table.
I designed a circel in TinkerCad with a diameter on 58mm wide and 15mm in height.
On top og that i made a circle with a hole in the same diameter of 58mm and set the wall for 1 which made it 3mm wide, so it wont brake off, so the hole is 55mm wide. I made the wall 10mm high, so the extender works like a cork and you dont need any screws.
Dimensions:
Bottom
58mm wide x 15mm high
Top
58mm wide x 3mm wall x 10mm high
You can modify the model for fitting your table leg. Measure the diameter and fit the model to it.
I attached a file from TinkerCad and the file from Cura. Guess Cura saves the settings from my printet setup.
Hope someone can use this.
Sandus also publishes on
6 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
