Table Mount Spool Holder (TUSH Remix)

Print in the orientation shown in the picture, doesn't require supports. Keeps the utility of TUSH, but adds a spool keeper when it runs low, and is adjustable for different spool thicknesses. Screws into your table top, or top of enclosure (Ikea Lack).

Uses standard 608 bearings, 8mm - 8.1mm ID rings. I printed it at 60% infill because I wanted it to be sturdy, and it only added 20-30 minutes to each print on an Ender 3. I had a successful print at 20%, but your mileage may vary. I recommend 60%, but it's not required. Printed at 205/60. This is a pre-scaled model, to account for thermal contraction, so there should be no need to scale up for the bearings to fit.

To print for one spool holder, 1x Mount, 2x Side_A, 2x Side_B.