Slicer Discord
Table Saw Blade Height Setup Block - Glue version – Modelo 3D imprimible de MakerWorld MakerWorld
Measure Tools

Table Saw Blade Height Setup Block - Glue version

20 Descargas
9 Likes
13 Makes
Ver Modelo
Print in your preferred filament; I used PETG, but pretty much any type should work well. You will need 4 8x3mm magnets (optional), glue, some scrap filament, and clamps (clamps are a must). Use glue that holds plastic well, of course. I used 5 min epoxy. I wouldn't suggest superglue, as you need enough work time to put it together and clamp it. You will only need a thin film, but make sure you get up near the corners. Use about 10mm of scrap filament in the small holes to align the halves for gluing. Make sure you align it properly! Make sure to clamp each corner to keep it accurate. Once it's dry, use a razor blade to shave off any excess glue.
Categoría
Measure Tools
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
postproceso considerable
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 2/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA, PETG
Postprocesado
Pegado, Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección