Table Saw height gauge tool

I designed a simple device to set the height of my table saw.

If used properly it can be quite accurate. But If you want a perfect result you ofc. still need to plane or grind the last few 1/10 mm down per hand.

In addition you will need a M6 x 20 Machinehead screw and a M6 Nut. If you don´t have these you may also print these parts but they might not last a long time if you don´t use a very tough material.

Have fun and keep printin!

Small tipps:
I designed the adjustable part so you can take the height without any measuring.


Check, where you are measuring the Saw teeth and keep the design of them in mind ,-)


Model Wood: You can screw this base to a piece of wood if your table saw is not very plane in the middle (Shit happens). Designed for 4 x M3,5 screws.