Thingiverse
Table tennis racket
von XxDonnaLauraxX
0
Downloads
1
Likes
0
Makes
Printed with PLA and TPU
The handle can be pushed in without glue and a little bit of force with a mallet.
The handle needs to be printed in vertical position.
The rubber part needs to be printed in soft TPU and glued on the PLA with contact glue
Printed with 30% infill 3 walls Normal PLA
Its a bit smaller then the official rackets so you could print it 120% sized.
The handle can be pushed in without glue and a little bit of force with a mallet.
The handle needs to be printed in vertical position.
The rubber part needs to be printed in soft TPU and glued on the PLA with contact glue
Printed with 30% infill 3 walls Normal PLA
Its a bit smaller then the official rackets so you could print it 120% sized.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
