Table Top Curling

Based on the great model by DorAndy. Change the infill to 15%. For some reason, my file kept being goofy, and it stayed stuck at 90% infill. Higher infill is ok, but a heavier rock seems to slide worse than a lighter infill. The initial goal for this project was to make a to-scale model of a curling rink that would fit on my tabletop. So I took a white sheet of coroplast that was 170 cm long, 36 cm wide and 1 cm thick. I then designed the project to have two rinks on one side, each scaled 1 ft = 1cm. On the other side, I designed the rings and curling stones to 1ft = 1 in, but shortened the rink to fit the board. I had to adjust the measurements a bit from there as my sheet of plastic wasnt cut perfectly. Also, I adjusted the rock sizes a bit to fit a 4.5 mm ball bearing for the 1cm scaled rink and a 12mm ball bearing for the 1 inch scaled rink. After testing, the 1cm-scale rocks were just a bit small, though still very playable. So I scaled them up a bit to fit a 7mm ball bearing. Thi