Thingiverse
Table top spool holder
von Ritie
4
Downloads
4
Likes
0
Makes
Spool holders I had been using didn't allow the spool to roll freely to release filament. I had some Misumi bearings HMRA30-6-F2.0 laying around and made this low friction spool holder. Any 5mm ID bearing with a grooved OD should work.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!