TableSaw Micro Adjuster

I designed this around my sawstop PCS with the t-glide fence. I imagine it would work with other fences, though the bottom lip on the fence block piece would be the only thing that would maybe need to change with other table saws/fences. parts list:2 - 8mm rods cut to 2 5/8" each - https://a.co/d/0edJgRNUMagnets 1.26 inch x 1/8 inch - https://a.co/d/07YHIufUNeoprene 1/16" - https://a.co/d/09G4RCXCMagswitch Magjig 95 - 81100041/4-20x2" bolt1/4-20 nut All halves were glued together with CA glue.Insert the nut into 1 half of the wheel, glue on the other half.Insert the bolt head into 1 half of the fence block, glue on the other half. The 8mm rod was not glued in. It's a tighter fit on the fence block, and a looser fit on the adjustment block so that everything slides without binding. I glued the first magnet to the bottom, and just kept adding magnets until it was flush with the top - 9 magnets in total. I glued little strips of 1/16" thick neoprene I had lying around