Tablet 10 Inch

This project is for the brave and courageous! The ten inch tablet was modelled from a typical over-the-counter paracetamol tablet (12.8mm diameter), and scaled up so that it is ten inches diameter. The scale is about 20-to-1. This was used in my send-up video as a tongue-in-cheek response to “all them reviewers out there”. The link on my channel is:
https://www.youtube.com/watch?v=OeTJlkV4LRM

There are two sets of files:
Full tablet (245mm diameter) - print one if it fits your printer.
Two quarter tablet models - print two of each.

When printing your full-size model, you will probably need to print out two of each quarter tablet model, for a total of four pieces. Select a low level of infill to reduce the amount of filament used, Use epoxy to glue the pieces together and fill in minor imperfections. Sand the model and paint it matt white.

Make sure that you have plenty of filament on-hand, heaps of time for printing and lots of time for finishing. Refer to your slicer soft