Thingiverse
Tablet Holder CD
door Gee_tech
1
Downloads
1
Likes
0
Makes
This is my first try at designing something that I needed to use my tabled in my car. Unfortunately non of the great uploads fitted my needs.
The insert gap is 16mm. If the gap is too wide, some of the thick double sider tape will assist.
The holder is 50mm X 50mm. 10mm deep overhang. The part that goes into the cd insert is 100mm. I made is that long as it greatly improves the stability.
As this will need to be printed twice (one side being mirrored) it can be adjusted for the width of the specific tablet. Hope this will help someone.
The insert gap is 16mm. If the gap is too wide, some of the thick double sider tape will assist.
The holder is 50mm X 50mm. 10mm deep overhang. The part that goes into the cd insert is 100mm. I made is that long as it greatly improves the stability.
As this will need to be printed twice (one side being mirrored) it can be adjusted for the width of the specific tablet. Hope this will help someone.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!