Thingiverse
Tabletop LCD1602 Case
von moridin1138
0
Downloads
0
Likes
0
Makes
Some "work in progress" cases for LCD1602 modules. I made these for a WEMOS D1 Mini Tripler board (small) and an SDS011 sensor (large).
They're meant to be printed on their fronts for a nice smooth front facing surface.
I am probably going to use some mesh screen for the backing, but will make and upload a back for these models as soon as I can.
There are dxf files included for both the large and small case. This will allow you to make a nice clean front out of clear or translucent acrylic in a laser cutter or cnc router. Either way you can use some screws to permanently affix the LCD screen to the case.
No supports needed, but some cleanup will be needed. A brim may be needed depending on how good your bed adhesion is.
They're meant to be printed on their fronts for a nice smooth front facing surface.
I am probably going to use some mesh screen for the backing, but will make and upload a back for these models as soon as I can.
There are dxf files included for both the large and small case. This will allow you to make a nice clean front out of clear or translucent acrylic in a laser cutter or cnc router. Either way you can use some screws to permanently affix the LCD screen to the case.
No supports needed, but some cleanup will be needed. A brim may be needed depending on how good your bed adhesion is.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
