Slicer Discord
Tactical Cat Ears – 3D-Druckmodell von Thingiverse Thingiverse

Tactical Cat Ears

42 Downloads
70 Likes
1 Makes
Zum Modell
A pair of cat ears to put on anything, based on the Halo Ears by Gerard2567. Works best with a headband on headphones (or hearing protection). The ears only need a short length of 3/4" double sided Velcro tape ([Like This](https://smile.amazon.com/dp/B00JWU77N2/ref=cm_sw_r_apan_glt_i_Z8DJ93WK8MEND7W0WDKM)) to wrap around the headband and attach it. *NOTE: This Velcro tape does NOT have adhesive, one side is the Loop and the other is the Hook, it will attach to itself and not the headband.* All you need to do is thread a length of this self-sticking Velcro tape through the hole at the base of the ears and around the headband, with the soft loop side facing out so it can't snag or be a nuisance.

I currently run these on a pair of Walkers Slim Electronic Muffs, but it will work on any headset/headphones that have a traditional headband. The earmuff band is about 50mm wide, so thats how wide these are, but it can be scaled in the Z axis to accommodate thinner headbands. They are also fa
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen